Yeti 68T 32-Pitch Steel Spur YT068TS by GPM  [YT068TS]

Axial Racing Yeti Steel #45 Spur Gear 32 Pitch 68T - 1pc - GPM YT068TS
Price:
USD$15.90
Brand:
GPM
Model:
YT068TS
GTIN:
4894538068962
Condition:
Brand New
Write a review
alt="Axial Racing Yeti Steel #45 Spur Gear 32 Pitch 68T - 1pc - GPM YT068TS" title="Axial Racing Yeti Steel #45 Spur Gear 32 Pitch 68T - 1pc - GPM YT068TS"

GPM precision spur for Yeti gearboxes

The steel 68T spur listed as GPM YT068TS is engineered as a direct replacement for Axial Racing Yeti gearboxes. With a 32 pitch tooth profile and CNC-quality finishing, it is intended to replace weaker plastic spurs where increased tooth strength and reliable mesh are needed for performance or longevity.

This spur functions as the primary gearbox gear, meshing with the motor pinion to allow ratio changes or drivetrain refurbishment. Installation follows standard procedures: remove the gearbox cover, document shim spacing and mesh, slide the spur onto its shaft or hub, then verify mesh and bearing alignment before final assembly.

Compared with plastic, steel produces a firmer contact and requires careful pinion alignment and shim selection to avoid premature wear. This item is specified for RC use on Axial Racing Yeti platforms only and is not intended for use on full-scale vehicles.

Specifications

  • Item: Spur Gear 68T 32 Pitch
  • Material: Steel
  • Model Number: GPM YT068TS
  • Compatibility: Axial Racing Yeti
  • Quantity: 1 pcs

Recommended when precision, durability and consistent gear engagement are required for Axial Yeti drivetrain upgrades and maintenance.

What tolerances should I check during fitment?

Confirm spur runout, shaft concentricity and pinion face alignment; ensure shim stack produces correct backlash consistent with 32 pitch gearing.

Are there recommended bearing upgrades?

If you plan to run higher torque or steel gearing, consider higher quality sealed bearings with tight radial play to maintain mesh under load.

How should I set gear mesh with a steel spur?

Set initial mesh with a paper shim, tighten gearbox, then remove paper and confirm a small visible clearance across the tooth face; recheck after a short run.