WT-01N Aluminium Completed Tie Rod WTN160 by GPM  [WTN160]

Tamiya WT-01N Aluminium Completed Tie Rod - 1set - GPM WTN160
Price:
USD$12.90
Brand:
GPM
Model:
WTN160
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision aluminium tie rod for WT-01N chassis

The WTN160 is a CNC-friendly aluminium completed tie rod engineered to fit the Tamiya WT-01N chassis, supplied as a ready-to-install steering linkage. Machined alloy construction gives a stiffer connection between the servo output and steering knuckles on 1/10 monster truck platforms, targeting reduced deflection and consistent steering geometry under load.

Installation requires standard steering removal and refit steps: remove stock tie rod ends, engage the completed aluminium assembly with existing ball cups or rod ends, then confirm neutral steering and toe alignment. Verify thread engagement and torque fasteners to recommended hobby settings to preserve thread integrity and joint life. Routine inspection of rod ends and threads will sustain long-term performance.

What are the main benefits of an aluminium completed tie rod?

Aluminium assemblies like the WTN160 increase steering stiffness, reduce flex compared to softer materials, and provide repeatable geometry for tuning and setup consistency.

How should I set up and check the part after fitting?

Centre the servo, attach the tie rod to ball cups, adjust for neutral steering, then measure toe at the wheels and fine-tune rod-end positions. Re-check fastener torque after an initial break-in run.

Are there any special maintenance steps for alloy tie rods?

Inspect for play at the rod ends, ensure threads remain clean and lightly lubricated where needed, and replace worn ball cups to maintain precise steering response.