TXMS143F/RSN adjustable CVD 8mm axle kit with 7075-T6 hex adapters TXMS143F/RSN by GPM  [TXMS143F/RSN]

Adjustable CVD drive shaft kit for MAXX

The kit replaces stock cross-pin drives with adjustable constant velocity swing joints to improve driveline load transfer on 1/10 TRAXXAS MAXX platforms. Each joint pairs a hardened steel coupling with a 6061-T6 alloy body to preserve torsional stiffness while limiting weight gain. The shaft profile increases axle diameter from 6mm to 8mm to better resist bending under widened track loads, and the length adjustability allows precise suspension setup.

Supplied components include precision 7075-T6 aluminum hex adapters and wheel locks sized for the larger shaft, plus 8x16x5 bearings that match the revised dimensions. The kit is configured for use on either front or rear drive shafts and wheel mounting for MAXX builds using +20mm widening kits.

For precision-minded builders upgrading a MAXX to a wider track, this kit provides thicker 8mm axles, hardened swing joints and 7075-T6 hex hardware to improve load handling and allow fine driveline length tuning.