TT-01 10mm Bronze Ball Joint Set for Upper and Lower Arms TT007 by GPM  [TT007]

Tamiya TT01 Bronze 10mm Ball For Up/Lower Arm set - GPM TT007
Price:
USD$3.90
Brand:
GPM
Model:
TT007
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical overview of TT-01 10mm bronze ball joints

This compact replacement set supplies 10mm bronze ball ends tailored for the upper and lower control arm attachment points on the Tamiya TT-01 chassis. The parts are intended to restore accurate linkage motion and reduce fitment play while preserving original suspension geometry.

Service and installation follow standard arm removal procedures: extract the affected arm, transfer the new ball ends into the existing ball cups and reassemble per the chassis manual. No specialised tooling is required beyond routine hobby hex drivers and inspection tools.

From a setup perspective the bronze contact surfaces provide a firmer interface than typical plastic ball ends, improving repeatability in steering feedback and suspension behaviour during tuning cycles on the TT-01 platform.

What should I check before fitting these ball ends?

Verify that your arms use 10mm ball ends and inspect ball cups for wear or deformation. Proper seating of the ball in the cup is essential for predictable geometry and load transfer.

Do these require any bedding or break-in?

A brief running period under light load is sufficient to seat the bronze contact faces; avoid heavy impact for the first few runs and recheck fastener torque and alignment.

How do they influence setup consistency?

Reduced clearance at the joint lowers random movement at the links, which helps maintain consistent steering geometry and makes incremental tuning changes easier to evaluate on the track.