TRX4 Linkage Ball End Replacement 12pc TRX4160A/BE by GPM  [TRX4160A/BE]

Precision replacement ball ends for TRX4 linkage assemblies

This 12-piece kit provides plastic ball ends specified as replacements for the TRX4160A assembly used on selected TRAXXAS TRX4 models. Each component is sized to fit the TRX4160A sockets and is supplied to restore articulation at steering and suspension link points without requiring full linkage replacement.

Use these ball ends to maintain correct steering geometry and suspension articulation on crawler setups. The set quantity allows servicing multiple joints or performing a complete axle overhaul. Inspect seating and rotational freedom during initial run-in and replace any unit that exhibits play beyond acceptable limits.

Fitting procedure: extract the worn ball ends from the TRX4160A locations, press the new ball ends into the original sockets ensuring full seating, then verify free articulation and secure fitment. Regular inspection after heavy use is recommended to confirm ongoing reliability.