TRAXXAS XRT/X-Maxx 35T Spur & 20T Input Gear XRT3520S by GPM  [XRT3520S]

Aftermarket steel spur and input gear for TRAXXAS XRT 8S

This aftermarket gear set is an RC-scale replacement designed for select TRAXXAS XRT and X-Maxx 8S platforms. The kit uses 20CrMnTi steel for the major gears and adds a 7075 aluminum fixed mount plus bearings to form a three-point support, which improves load distribution and transmission stability compared with the original two-point support design.

The set combines a 35T spur gear with M1.5 module and a 20T transmission input (motor) gear with M1.0 module in an integrated motor-gear and input-shaft arrangement that removes the older 2.5mm locating pin. Key measured values supplied by the manufacturer include a 35T spur with a 6mm diameter D-shaped motor hub opening, 14mm tooth width and approximately 55.4mm outer diameter, and a 20T motor gear with 1.0 module.

Use this kit where the goal is to reduce wear and improve gear mesh consistency under high torque from 8S-power setups. Note the part is specifically not suitable for TRAXXAS 1/5 X-Maxx 8S Monster Truck-77096-4 as stated by the manufacturer.

For builders and repairers of 8S TRAXXAS XRT and X-Maxx models, this GPM kit upgrades the OEM spur and input gears to hardened 20CrMnTi steel and includes a 7075 mount to enhance wear resistance and transmission steadiness under high load.