TRAXXAS X-MAXX Shock Shaft Upgrade TXM12170/SH by GPM  [TXM12170/SH]

TRAXXAS X-MAXX Medium Carbon Steel Front/Rear Shock Shaft - 1pr - GPM TXM12170/SH
Price:
USD$10.90
Brand:
GPM
Model:
TXM12170/SH
GTIN:
4894538366679
Condition:
Brand New
Write a review

Medium carbon steel service shafts for X-MAXX dampers

This aftermarket shaft set offers a direct-fit replacement for 1/5 TRAXXAS X-MAXX damper assemblies and is intended for routine damper rebuilds and straightforward tuning changes. Shafts are delivered as a matched pair for front or rear damper installation and are provided as RC maintenance parts.

In damper maintenance the shaft forms the guiding surface for piston and seal assemblies; installing new shafts can reduce seal abrasion and restore consistent damper travel. Confirm damper bore condition and seal integrity during fitting and replace any worn seals or bushings to maintain proper damping characteristics.

Service procedure: remove the damper from the chassis, drain shock oil and disassemble according to the damper manual. Pass the shaft through the piston and seal stack, verify shaft end profiles match the shock cap and piston retainer, then reassemble using the oil weight and travel configuration appropriate to your application.

Packing includes

  • Shock shafts - 2pcs

Original Name / Part No:

7763

Compatible Models

  • TRAXXAS-1/5 4WD X-MAXX 6S
  • TRAXXAS-1/5 ELECTRIC 4WD X-MAXX 8S MONSTER TRUCK

What tolerances should I expect from these shafts?

Shafts are produced to hobby-grade dimensional tolerances suitable for standard X-MAXX assemblies; check runout and end geometry before assembly for high-precision builds.

Do these shafts require special lubrication?

Use standard shock oil and light assembly grease on seals as recommended by your damper manual; correct lubrication reduces wear and extends service life.

Are these shafts compatible with aftermarket caps and retainers?

Compatibility depends on cap and retainer geometry; verify that the shaft end profile matches your chosen hardware before final assembly to ensure secure retention and sealing.