TRAXXAS X-MAXX Precision Rear Wheel Hex Claw +3mm with Brake Disk TXM006R/DISK by GPM  [TXM006R/DISK]

Precision CNC rear hex claw for X-MAXX hubs

This CNC-machined aluminium rear wheel hex claw with an integrated brake-disk mounting face is engineered as an aftermarket upgrade for TRAXXAS X-MAXX rear hubs. The component delivers a fixed +3mm offset and a machined locating surface to reduce lateral play and improve positional repeatability under heavy torque and load cycles.

Constructed from billet-grade aluminium, the hex claw minimises deformation at the wheel-seat compared with polymer originals, yielding more consistent tyre seating and more predictable wheel runout after repeated tyre changes or high-power operation. The brake-disk face functions as a precision locating surface and does not replace or alter the vehicle braking assembly.

Installation notes: the part installs as a direct rear hex for TRAXXAS X-MAXX hub specifications and uses the same mechanical retention as factory hexes. Install with the correct screw dimensions and specified torque to protect wheel studs and threads. Inspect mating surfaces and thread interfaces at service intervals and apply thread locker where drivetrain maintenance guidance specifies it.

For serious hobbyists and tuners seeking a durable, low-profile wheel mounting with a controlled +3mm offset, this precision aluminium hex claw improves wheel seating and repeatability without altering hub geometry.