TRAXXAS X-Maxx +1mm Aluminium Wheel Hex Claw TXM006/+1 by GPM  [TXM006/+1]

Precision aluminium wheel hex for X-Maxx

This aluminium wheel hex claw is engineered for TRAXXAS 1/8 X-Maxx use and supplied as a matched pair, offering a +1mm offset to adjust wheel engagement. The component is specified as a direct replacement hex intended to interface with standard X-Maxx hub assemblies while keeping the upgrade focused on wheel positioning and clamp reliability.

Apply the claw where a measured offset helps clear tyre rub, seat aftermarket rims more securely, or fine-tune track width for handling balance. The aluminium construction emphasises dimensional control and resistance to wear compared with standard plastic hexes, aiding consistent wheel mount performance under repeated load cycles.

Install using standard wheel removal and refit procedures: remove the wheel and existing hex, fit the aluminium claw to the hub, verify flush seating, then refit and torque the wheel per original guidance. Verify wheel runout and retention in a short test before routine operation.

For precision-minded builders upgrading TRAXXAS X-Maxx wheelsets, the +1mm aluminium hex claw provides a focused solution for fitment and improved wear characteristics without hub modification.