TRAXXAS X-Maxx 1/8 18T Hardened Steel Pinion TXM018TS by GPM  [TXM018TS]

TRAXXAS 1/8 X-Maxx Steel Motor Gear (18T) - 1pc - GPM TXM018TS
Price:
USD$10.90
Brand:
GPM
Model:
TXM018TS
GTIN:
4894538190069
Condition:
Brand New
Write a review

18T hardened steel pinion for X-Maxx applications

This hardened 18T steel motor gear is offered as a single aftermarket pinion for the TRAXXAS 1/8 X-Maxx. It is specified for direct replacement of the motor pinion to recover correct motor-to-geartrain engagement using an 18-tooth hardened steel profile.

Install this pinion when replacing a fatigued or damaged motor gear or when recalibrating gear ratios during tuning. The hardened steel construction preserves tooth geometry under repeated torque cycles and supports consistent mesh under demanding loads.

Technical fitment notes: remove the motor assembly to access the pinion, set mesh and backlash precisely against the spur gear, and confirm the set-screw is fully seated. Perform initial run checks and periodic inspections of tooth condition and fastener security to maintain reliable operation.

This item is compatible with

  • TRAXXAS XMAXX
  • TRAXXAS XO 01

What is supplied with this part?

One steel motor gear, sold as 1 pcs.

Which platform is this intended for?

This pinion is intended for the TRAXXAS 1/8 X-Maxx platform; verify shaft and bore specifications before adapting to other motors.

Best practice for initial setup?

Set a conservative backlash, run the drivetrain briefly to seat the gears, then retighten the set-screw and re-check mesh to confirm stable engagement under torque.