GPM TRX419A21 CNC Aluminium Front C Hub and Knuckle Assembly for TRAXXAS TRX4  [TRX419A21]

Precision aluminium front end upgrade for TRX4 platforms

This GPM CNC aluminium front C hub and knuckle arm set is manufactured from 6061 T6 material to provide repeatable steering geometry and increased resistance to wear when fitted to a TRAXXAS TRX4. The anodised surface finish helps protect contact areas while allowing adjustable damper placement for refined suspension setup.

Technical Highlights

• Material Quality: 6061 T6 aluminium stock offers an optimal balance of stiffness and weight for chassis tuning and longevity.
• Enhanced Steering Stability: Precision Delrin collars are used to remove free play and maintain consistent track alignment under load.
• Smooth Operation: Stainless steel king pins are included to replace the original plastic fittings, improving pivot durability and reducing wear on mating surfaces.
• Adjustable Dampers: The hub form allows the damper mount to be offset outward to alter roll centre and ride height in measured increments.

Packing includes

• Front C-Hub - 2pcs
• Aluminum Front Knuckles Inner Part - 2pcs
• Aluminum Front Knuckle Outer Case - 2pcs
• King Pin - 4pcs
• Stainless Steel Flat Head Screws 2.5x10 - 6pcs
• Stainless Steel Round Head Screws 3x14 - 2pcs
• Stainless Steel Round Head Screws 3x16 - 4pcs
• Stainless Steel Round Head Screws 3x18 - 4pcs
• Stainless Steel Round Head Screws 3x20 - 2pcs
• Aluminum Collar 3x6x2 - 6pcs
• Stainless Steel Round Head Screw 2.5x4 - 6pcs
• Stainless Steel Cap Head Screws 2.5x8 - 4pcs
• Stainless Steel Cap Head Screws 2.5x10 - 12pcs

Original Name / Part No:

8232+8252+8251