TRAXXAS TRX-4 Precision CNC Side Steps Adjustable Slot Mount - TRX4014XB by GPM  [TRX4014XB]

Precision aluminium side steps for TRX-4

Designed for TRAXXAS TRX-4 platforms, these precision aluminium side steps are supplied as a 10pcs kit including two CNC-cut side plates and eight stainless steel round head screws. The plates are CNC machined, anodized, and engraved with a reticulated (pattern B) texture to deliver repeatable surface contrast and durable scale appearance.

The mounting interface uses an elongated screw slot allowing controlled lateral adjustment so each plate can be positioned inward or outward during fitting. This slot-based method supports minor fitment tuning without bending or trimming the component, preserving alignment and finish quality.

Intended use is cosmetic enhancement and light contact protection: the parts provide a low-profile ledge to reduce brush abrasion on lower body edges while maintaining vehicle dynamics. They do not alter suspension geometry, steering response, or drivetrain operation.

Assembly recommendations: use the supplied 3x10 stainless steel round head screws, perform test fitting with the body shell in place, and tighten incrementally to avoid misalignment. If thread resistance occurs from surface finish, clean mating threads and apply steady torque to prevent thread damage to mounting points.

The TRX4014XB set is a precision-minded cosmetic upgrade for TRX-4 crawlers, combining CNC machining, anodized finish and an engraved reticulated surface for consistent appearance and fitment control.