TRAXXAS TRX4 CNC Anodised Side Steps Technical TRX4014XA by GPM  [TRX4014XA]

Precision aluminium side steps for TRX4 platforms

These CNC-machined aluminium side steps are intended as scale accessories for TRAXXAS TRX4 trail crawler platforms and are catalogued under TRX4014XA. Components are produced with an anodised surface treatment and a post-anodise engraved reticulated pattern to produce visible contrast, with CNC profiling to ensure consistent dimensional tolerance and edge finish. The design focuses on appearance, secure modular mounting and repeatable alignment rather than structural load bearing.

The assembly uses adjustable screw-area plates that permit lateral offset adjustments so the steps can be located slightly inward or outward relative to the chassis rails. The kit contains the required stainless steel fasteners and allows for controlled visual and clearance tuning; these adjustments are not intended to affect suspension geometry.

Installation guidance: attach the left and right steps to the indicated mounting points using the supplied screws, adjust the screw plate position to set the desired offset, and apply appropriate torque to prevent thread damage while preserving the anodised finish.

A technical scale upgrade that pairs CNC accuracy with anodised finish and adjustable mounting for refined side-step alignment on TRX4 crawlers.