TRAXXAS Slash 4x4 Precision Low-CG Aluminium Adapter with 56T Spur and 15T Pinion SLA155615TLG by GPM  [SLA155615TLG]

Precision aluminium adapter mated to hardened steel 32-pitch gears

This set supplies an aluminium low-mass gear adapter engineered to precise tolerances and paired with hardened steel 32-pitch spur and motor gears for RC-scale use on TRAXXAS Slash chassis. The matched components are intended to replace the stock adapter and gears on the specified version to provide consistent alignment between motor output and the drivetrain.

At the core is a 56T hardened steel spur and a 15T hardened steel motor gear designed for 32-pitch systems, with an aluminium adapter that positions the motor to maintain optimal gear mesh and alignment. The steel gearset is selected for extended wear life under normal and tuned running conditions.

For tuners, changing the motor gear modifies the final drive ratio; common pinion sizes paired with a 56T spur span 13T to 20T, allowing careful selection to bias the vehicle toward quicker acceleration or higher top speed depending on setup goals.

• Supplied as a matched 56T spur and 15T motor gear optimised for 32-pitch systems.
• Lightweight aluminium adapter to set motor position for low-CG Slash 4x4 configurations.
• Hardened steel spur and pinion for improved wear resistance and consistent engagement.

Assembly guidance: establish correct gear mesh and axial alignment before final tightening, retain compatible fasteners where appropriate, and confirm pinion clearance to avoid binding. This is an aftermarket replacement and tuning component intended for the model version listed below.

Use this precision-matched kit when you need a hardened 56T spur and a fixed 15T pinion installed via a low-mass aluminium adapter to improve drivetrain stability and wear characteristics on the specified Slash variant.