TRAXXAS SLASH 4X4 Front C Hub CNC-Grade King Pin Replacement SLA019AP by GPM  [SLA019AP]

Price:
USD$4.90
Brand:
GPM
Model:
SLA019AP
GTIN:
4894538320152
Condition:
Brand New
Write a review

Engineered stainless king pin for front hub repair

This four-piece stainless king pin set is specified for the front C hubs of TRAXXAS SLASH 4X4 platforms and is intended for hobbyist-level suspension maintenance and tuning. Each pin provides a corrosion-resistant pivot surface to replace worn hub bores without modifying suspension geometry.

Service procedure follows standard hub refurbishment: remove wheel and hub assembly, extract the degraded pin, align and press the stainless pin into the hub bore, and reinstall factory retaining hardware. Use light press force and proper support to avoid hub deformation; the set services both front positions in one kit.

Replacing worn king pins reduces axial and rotational slack at the steering pivots, restoring repeatable steering characteristics and improving the baseline for further tuning or setup work.

This item is compatible with

  • TRAXXAS Slash 4X4
  • TRAXXAS XO 01

How do these pins align with original hub tolerances?

Pins are manufactured to match nominal hub bore dimensions for TRAXXAS SLASH 4X4 front C hubs, providing a direct-fit replacement that preserves factory tolerance stack-up.

Recommended installation practice to avoid bore damage?

Support the hub securely, use an arbor press or controlled punch, and ensure axial alignment to prevent canting; inspect the bore for scoring before installation.

When should these pins be replaced in a maintenance cycle?

Replace when measurable play appears at the steering pivot or when visual wear is present on the pin or bore, typically after extended use or high-contact running conditions.