TRAXXAS Slash 4X4 7075 Tie Rod And Stabiliser Precision Upgrade SLA049LCGN by GPM  [SLA049LCGN]

Machined 7075 tie rod assembly for Slash 4X4

This precision front tie rod assembly is engineered for the TRAXXAS Slash 4X4 steering architecture, providing a direct replacement for stock tie rods and C-hub mounting points. Manufactured from 7075 aluminium, the components focus on tensile performance and reduced mass while maintaining the required steering geometry for stock turnbuckle layouts.

The subassembly integrates a stabiliser and a triangular reinforcement to increase lateral stiffness at the steering knuckle without compromising suspension articulation. The adjustable rod features a counter-clockwise threaded end fitting to lock tie rod ends in place and enable precise toe adjustments during setup or tuning iterations.

Typical installation locations are the top of the C-hub, the front gearbox side mounts and the centre support where the stabiliser interfaces with the chassis. This hop-up is intended to improve steering repeatability and provide a robust adjustment range for competitive and recreational use.

Use this 7075 aluminium tie rod and stabiliser assembly to reduce steering flex and gain fine adjustability on Slash 4X4 platforms; follow standard RC fitting practice and verify thread orientation during assembly.