TRAXXAS Slash 4x4 17mm Hex Adaptor SLA010/+17MM by GPM  [SLA010/+17MM]

Professional alloy hex adaptor for Slash 4x4

This 4pc alloy hex adaptor set fits the TRAXXAS Slash 4x4 1/10 chassis and supplies a +17mm offset option to alter wheel position for tyre clearance and track width tuning. The design emphasises accurate fitment and repeatable offset for consistent setup changes.

Install by replacing the stock hex adaptors with these alloy units to move the wheel mounting point outward by +17mm, then validate tyre clearance and suspension articulation. The set includes four adaptors to service every wheel on a Slash 4x4, enabling balanced stance adjustments across the axle.

Workshop notes: perform standard wheel removal, apply correct wheel nut torque and inspect steering and suspension range of motion after fitment. Use initial test runs to confirm no drivetrain or steering interference and to fine tune alignment settings.