TRAXXAS Slash 1/10 4x4 Precision Replacement Pin SSLA1277RH/P by GPM  [SSLA1277RH/P]

TRAXXAS 1/10 Slash 4x4 Steel Pin For TRAXXAS Slash CVD SSLA1280FH/SSLA1277RH - 2pc set - GPM SSLA1277RH/P
Price:
USD$0.20
Brand:
GPM
Model:
SSLA1277RH/P
GTIN:
4894538332360
Condition:
Brand New
Write a review
alt="TRAXXAS 1/10 Slash 4x4 Steel Pin For TRAXXAS Slash CVD SSLA1280FH/SSLA1277RH - 2pc set - GPM SSLA1277RH/P" title="TRAXXAS 1/10 Slash 4x4 Steel Pin For TRAXXAS Slash CVD SSLA1280FH/SSLA1277RH - 2pc set - GPM SSLA1277RH/P"

Precision CVD pin

This replacement steel pin is intended for the CVD joint on 1/10 TRAXXAS Slash 4x4 models and uses the model identifier SSLA1277RH/P. It serves as the locating pin that secures CV yoke and cup interfaces to maintain accurate drivetrain geometry.

Compatibility specification: designed for use with TRAXXAS Slash CVD assemblies referenced by SSLA1280FH and SSLA1277RH. Verify part codes on the vehicle to confirm interchangeability prior to installation.

Installation procedure: access to the driveshaft and CVD housing is required to remove the existing pin and fit the replacement. Inspect mating bores and retaining hardware during service and preserve original orientation and clearance on reassembly.

Service impact: replacing a fatigued or worn pin reinstates precise locating of CVD components, reducing endplay and improving driveline responsiveness. Include pin inspection in routine maintenance to prevent progressive wear to adjoining parts.

Contents: two steel pins supplied as a matched replacement pair for the specified TRAXXAS CVD locations, compatible with SSLA1277RH / SSLA1280FH.

This item is compatible with

  • TRAXXAS Slash 4X4
  • TRAXXAS SLASH 4X4 LOW CG
  • TRAXXAS Stampede 4X4 VXL
  • TRAXXAS Rustler VXL
  • TRAXXAS CRANIAC

What exact component does this replace?

It replaces the steel locating pin found in the CVD joint area on TRAXXAS Slash assemblies referenced by SSLA1280FH and SSLA1277RH.

Are both pins matched for fit?

Yes, the package includes two pins supplied as a matched pair to maintain consistent fit and alignment across both joint locations.

Recommended inspection points during replacement?

Check the CVD bore, yoke faces and retainers for scoring or wear, and confirm pin seating and clearance before final assembly to ensure reliable driveline operation.