TRAXXAS Slash 1/10 4x4 Low-CG aluminium shock and wheel upgrade RUS488910 RUS488910SA by GPM  [RUS488910SA]

Precision LCG shock and wheel upgrade for Slash 1/10 4x4

This precision-engineered aftermarket set is crafted for TRAXXAS Slash platforms, combining CNC-friendly aluminium shock bodies with hardened drivetrain components and hex wideners to lower centre of gravity while retaining serviceable stiffness. The package includes matched front and rear shortened shocks, hardened steel #45 axle internals, spring-steel hex wideners, rubber tyres on plastic rims, plus aluminium collars and stainless fasteners for reliable geometry adjustment and body clearance management.

Front and rear shock lengths are supplied at 75mm and 80mm respectively, permitting closer chassis ride heights without major chassis modification. Two spring wire thicknesses are provided for tuning: gold 2.6mm and silver 2.2mm. Tuning is achieved by spring swaps or by varying top-screw preload; the CVD assemblies incorporate hardened #45 steel internals and 6061-T6 aluminium bodies to deliver improved torsional control with economical mass distribution.

Track widening uses spring-steel hex wideners that increase offset by 3mm per side (6mm total), yielding better lateral stability for high-speed flat-surface runs. The supplied tyres and rims provide predictable contact patches for consistent steering response. This component set is intended for model use only and should be inspected after heavy impacts.

This 68-piece low-CG solution targets model builders seeking precise lowering and improved high-speed lateral stability on flat surfaces; adjust collar spacing and select springs to achieve the desired ride height and handling balance.