TRAXXAS Revo Precision Throttle & Brake Linkage TRV1325 by GPM  [TRV1325]

CNC-grade alloy throttle and brake linkage for Revo

The TRV1325 is an aftermarket alloy throttle and brake linkage developed for TRAXXAS Revo and Revo 3.3 platforms. Machined alloy components combined with Delrin bearings reduce pivot friction and extend service life compared with stock plastic parts while maintaining standard Revo control geometry.

As a direct replacement for the original lever assembly, the TRV1325 provides a rigid mounting surface and engineered low-friction bushings at critical pivots. The design supports precise throttle and brake setup adjustments and reduces progressive wear on pivot points during regular use and competition.

Installation follows conventional Revo mechanical procedures: remove the stock lever, transfer necessary linkages and hardware, and secure the alloy unit in the OEM mounting position. Verify smooth, full-range movement, confirm clearance at maximum travel, and fine-tune linkage lengths or servo centring to restore accurate throttle and brake geometry.

Periodic inspection is recommended after initial runs to confirm bushing condition and fastener security. Where necessary replace worn bushings to preserve precise operation and minimise bearing play under load.