TRAXXAS MAXX Adjustable Front and Rear CVD Drive Shaft TXMS3F/RSA/2 by GPM  [TXMS3F/RSA/2]

Adjustable front and rear CVD drive shafts for MAXX

This TXMS3F/RSA/2 set is a precision-engineered, RC-scale front and rear drive shaft upgrade intended for the TRAXXAS MAXX MONSTER TRUCK. The kit replaces cross-head style half-shafts with CVD swing joints to deliver a more consistent torque path under load while maintaining a lightweight assembly compatible with hobby model axles.

The configuration utilises hardened steel at the joint interfaces coupled with 6061-T6 aluminum bodies to provide a balanced combination of contact durability and reduced rotating mass. The adjustable bodies permit fine trimming of suspension geometry to minimise binding during travel, and the supplied screw pins retain the CVD assemblies on the existing axle interfaces.

Installation overview: the kit is designed for direct replacement where stock spline and pin locations match; install requires disassembly of the wheel hubs and drive components and fitting the included pins to secure the CVD elements. After assembly, verify free rotation through suspension travel and re-check torque on all fasteners prior to operation.

Engineered for reliable aftermarket performance, this set pairs hardened joint surfaces with 6061-T6 aluminium bodies to enhance driveline durability and reduce binding in aggressive RC use.