TRAXXAS GT4 TEC 2.0 Precision Rear Tie Rods 6061 T6 7pcs GT049R by GPM  [GT049R]

This 7pcs rear tie rod kit is supplied for TRAXXAS 4WD GT4 TEC 2.0 applications to reinforce and stabilise the rear steering linkage. Produced from aluminium 6061 T6, the components are specified to provide a consistent strength-to-weight profile suitable for measured tuning work and repeatable handling adjustments.

Engineering and setup notes:

• Material: aluminium 6061 T6 chosen for predictable mechanical properties and weight savings.
• Adjustability: counter-clockwise threaded rod ends permit controlled length variation for toe and steering geometry calibration.
• Geometry: triangular reinforcement at the mounting area improves load distribution and steering balance while maintaining designed flex characteristics.
• Fine tuning: multiple pre-drilled positions give stepped angle options for repeatable incremental toe adjustments.

Assembly guidance: confirm thread orientation prior to removal of existing parts, proceed with incremental length changes while measuring toe or tracking response, and torque fasteners to secure alignment. These components are intended as tuning hardware to refine rear steering behaviour on touring car setups rather than to indiscriminately stiffen the rear end.

Included hardware: Stainless Steel Flat Head Screw 3x18 - 2pcs, Stainless Steel Round Head Screw 3x8 - 2pcs.

This item is compatible with

• TRAXXAS FORD GT4-TEC 2.0