TRAXXAS FUNCO PRO SCALE 2WD Precision 15T Transmission Top Gear TPS015TS by GPM  [TPS015TS]

TRAXXAS FUNCO PRO SCALE 2WD SAND CAR High Carbon Steel 15T Transmission Top Gear - GPM TPS015TS
Price:
USD$18.90
Brand:
GPM
Model:
TPS015TS
GTIN:
4894538404630
Condition:
Brand New
Write a review
alt="TRAXXAS FUNCO PRO SCALE 2WD SAND CAR High Carbon Steel 15T Transmission Top Gear - GPM TPS015TS" title="TRAXXAS FUNCO PRO SCALE 2WD SAND CAR High Carbon Steel 15T Transmission Top Gear - GPM TPS015TS"

Precision 15T transmission top gear

This 15T transmission top gear is a precision machined high carbon steel replacement intended for the TRAXXAS FUNCO PRO SCALE 2WD gearbox. Manufactured to maintain original geometry, the gear is specified as a direct swap for the factory part to preserve drivetrain alignment and tooth engagement.

Engineered for improved wear resistance, the component is supplied as a single item and installs into the listed FUNCO PRO SCALE 2WD gearbox without modification. Installation best practice is to inspect shaft tolerances and bearing condition, set correct gear mesh with measured backlash, and apply a light gear grease for controlled break-in to stabilise contact patterns.

Packing includes

  • 15T Transmission Top Gear - 1pcs

Original Name / Part No:

10960

Compatible Models

  • TRAXXAS 1/6 FUNCO PRO SCALE 2WD SAND CAR 8S-109076-4

A precision replacement gear intended to restore correct mesh and extend service life of the transmission while maintaining original fit and tolerances.

What inspection steps are recommended before fitting?

Verify bearing radial play, check shaft straightness and remove any burrs on mating surfaces to ensure the new gear seats correctly and runs true.

How should gear mesh be set for optimal contact?

Set a minimal consistent backlash, apply a thin film of grease on tooth flanks, rotate the gearbox to establish contact patterns, then fine-tune until even contact is achieved across teeth.

Are heat treatment or hardening details provided?

The component is produced from high carbon steel with hardness suited for transmission use to improve wear resistance compared with standard materials; follow normal maintenance and inspection intervals.

Does this gear alter drivetrain geometry?

No. The gear is manufactured to match original dimensions and is intended to preserve the factory gearbox geometry and maintain alignment when installed correctly.