TRAXXAS E-REVO Front Drive Shaft Set ER037SF technical upgrade by GPM  [ER037SF]

TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF
Price:
USD$23.90
Brand:
GPM
Model:
ER037SF
GTIN:
4894538274035
Condition:
Brand New
Available in shop
1 Reviews
Write a review
alt="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF" title="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF"
alt="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF" title="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF"
alt="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF" title="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF"
alt="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF" title="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF"
alt="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF" title="TRAXXAS E-REVO Steel #45 Front Drive Shaft-4pc set - GPM ER037SF"

Technical overview for 1/10 TRAXXAS front driveline

The 4 pcs front drive shaft set is an aftermarket engineering replacement for RC-scale TRAXXAS platforms. Manufactured in steel #45, the shafts are intended to improve front driveline durability on 1/10 E-REVO and Summit models while remaining for hobby use only. The adjustable design supports precise driveline length control during setup.

Engineering details: the shafts are adjustable between 75mm and 80mm to accommodate differing steering geometry and suspension travel, with steel retaining rings fitted at both ends to secure the screw pins. This arrangement facilitates routine driveline tuning and helps maintain alignment under dynamic load.

Hardware included as listed: 6x8x5 aluminium collar - 1 pcs, and 2.5xM4Tx15 screw pin - 2 pcs. Follow standard installation practice and inspect retaining rings periodically to prevent pin migration in service.

Compatible Models

  • 1/10 E-REVO
  • SUMMIT

For precision setups and durability-focused upgrades on TRAXXAS E-REVO and Summit 1/10 chassis, the ER037SF steel #45 4 pcs set provides a clearly adjustable and secure front driveline solution.

 

Product Reviews
1 Reviews
rating
GPM parts are awesome! I was working with Zoe on my order and everything was great, thank you so much!

What tolerances should I check during installation?

Verify shaft length within the 75-80mm band, check for free rotation at the hubs, and ensure retaining rings are fully seated to avoid axial play.

Can these shafts be heat-treated or hardened further?

The parts are supplied as steel #45; any additional heat treatment should be performed by a qualified workshop and may alter dimensions and fitment, so proceed with caution.

Recommended maintenance interval?

Inspect retaining rings and screw pins after the first few runs, then as part of routine maintenance every few sessions or after heavy impacts.

How does the adjustable range affect camber and toe?

Changing shaft length within the 75-80mm range can alter hub position slightly; verify wheel alignment after adjustment to keep camber and toe within desired settings.