TRAXXAS E-REVO Aluminium Steering Holder ER048A by GPM  [ER048A]

TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A
Price:
USD$14.90
Brand:
GPM
Model:
ER048A
GTIN:
4894538265200
Condition:
Brand New
Available in shop
Write a review
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"
alt="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A" title="TRAXXAS E-REVO Aluminium Steering Holder - 1pc set - GPM ER048A"

Technical steering holder for E-REVO

This single-piece aluminium steering holder is produced for the TRAXXAS E-REVO platform and supplied as 1pcs. It serves as a direct replacement for the factory holder, using aluminium to increase stiffness where the servo output meets the steering linkage.

Install this component when increased pivot stiffness is required to reduce flex and preserve steering geometry during tuning. The holder stabilises servo torque transfer and the steering link anchor points so adjustments to toe, Ackerman and servo endpoints remain repeatable under load.

Fitment notes: the part is dimensioned for the E-REVO steering assembly; verify bolt pattern and alignment before final torque and re-centre the servo horn after fitting. Regular inspection of screw torque and any play at link pivots will maintain consistent steering behaviour.

This item is compatible with

  • TRAXXAS E-REVO

What mounting checks are recommended?

Confirm bolt hole alignment and spacing match the E-REVO steering assembly prior to final torque. Incorrect alignment can introduce unwanted binding or play.

How does this part affect tuning?

By increasing structural stiffness at the servo-to-linkage interface, the holder reduces variable flex and helps make toe and Ackerman adjustments more consistent across runs.

Routine service advice?

Inspect fastener torque after initial installation and at regular intervals, and check link pivots for play to ensure repeatable steering performance.