TRAXXAS Craniac Aluminium Front Mount Holder and Spring Steel Tie Rod Assembly CRA049S by GPM  [CRA049S]

Precision front mount holder and spring steel tie rod set

This aftermarket front mount holder and tie rod assembly is designed for the TRAXXAS 1/10 Craniac chassis and supplied as a single engineered set. The aluminium holder replaces the factory plastic mount to increase pivot stiffness, while the spring steel tie rods deliver a controlled combination of strength and elastic compliance to limit binding during suspension travel.

Installation requires front steering knuckle removal and replacement of the stock mount with the machined aluminium piece, followed by tie rod installation. Use standard hex tools and verify thread engagement and steering geometry after fitting; the assembly is intended to use the vehicle's original hardware where compatible.

In performance terms the aluminium mount reduces front-end deflection on hard impacts and the spring steel tie rods allow measured flex to preserve trail feedback. This balance improves steering precision without introducing excessive rigidity that would transfer shock loads to other steering components.

Engineered to deliver a stiffer front pivot and refined steering feedback for TRAXXAS Craniac setups; inspect all linkages after high-impact runs.