TRAXXAS 1/8 X-Maxx CNC-Grade 16T Motor Pinion TXM016TS by GPM  [TXM016TS]

TRAXXAS 1/8 X-Maxx Steel Motor Gear (16T) - 1pc - GPM TXM016TS
Price:
USD$10.90
Brand:
GPM
Model:
TXM016TS
GTIN:
4894538189865
Condition:
Brand New
Write a review

Precision 16T steel pinion for X-Maxx

This precision steel 16-tooth motor pinion is an engineered aftermarket replacement suited to TRAXXAS 1/8 X-Maxx motor interfaces and is supplied as 1 pcs. It operates as the motor-side pinion, transmitting torque to the drivetrain in hobby electric systems where accurate, repeatable fitment is required.

Engineering note: designed to match the X-Maxx motor interface profile referenced in the title, the pinion replaces worn or damaged motor gears without changing the specified 16-tooth ratio. Attention to gear mesh and correct set-screw engagement is essential to maintain service life and avoid premature wear.

Assembly guidance: install using standard precision pinion fitting practice, verify axial alignment and secure mounting on the motor shaft, then hand-rotate the drivetrain to confirm smooth engagement with the spur gear prior to dynamic testing. Initial low-load tests are recommended to validate installation.

This item is compatible with

  • TRAXXAS XMAXX
  • TRAXXAS XO 01

What tolerances should I check?

Check axial runout on the motor shaft and ensure the pinion seats flush; verify minimal lateral play and correct mesh with the spur gear to avoid edge loading.

Material and finish details?

The pinion is manufactured from heat-treated steel for wear resistance and dimensional stability under normal hobby use; inspect for burrs and clean before assembly.

Recommended installation checks?

Confirm correct axial position, torque the set-screw to spec for your motor shaft, verify smooth free rotation, and perform initial low-speed testing to monitor bearing and gear temperatures.