TRAXXAS 1/8 X-Maxx 22mm Aluminium Wheel Cone Locker TXM005N by GPM  [TXM005N]

TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N
Price:
USD$21.90
Brand:
GPM
Model:
TXM005N
GTIN:
4894538036565
Condition:
Brand New
Write a review
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"

Aluminium wheel cone locker for X-Maxx hubs

This aluminium cone wheel locker is an aftermarket replacement intended for TRAXXAS 1/8 X-Maxx platforms. The tapered cone locates and compresses the wheel against the hub to maintain seating under high speed and heavy load conditions common to large-scale off-road use.

Supplied as a set of four, the components are sized for a 22mm wheel hex interface and finished with anodizing to help resist corrosion and provide consistent fit. Installation follows conventional X-Maxx hub procedures and the cone profile is designed to seat without hub modification.

Specifications

  • Item: Wheel Cone Locker, 22mm, 4pcs
  • Material: Aluminium
  • Model Number: TXM005N
  • Compatibility: TRAXXAS 1/8 X-Maxx

Recommended as a durable aluminium replacement for worn or damaged plastic retainers, these cones help ensure repeatable preload and consistent wheel seating on TRAXXAS X-Maxx models.

This item is compatible with

  • TRAXXAS XMAXX
  • TRAXXAS X MAXX 8S Monster Truck

What hub interface do these cones require?

The cones are made for a 22mm wheel hex interface as used on TRAXXAS 1/8 X-Maxx hubs. Confirm hub face dimensions to ensure correct seating.

Is any surface preparation needed before fitting?

Clean the hub and cone seating faces of grease and grit, then test-fit to verify even contact. Tighten to the recommended hardware torque and recheck after initial runs.

How should these be inspected during maintenance?

Inspect for nicks, deformation or anodize wear at the seating surface. Replace cones showing significant damage to avoid uneven preload or wheel runout.

Can these be used with aftermarket wheel hex adapters?

They are intended for direct fit to 22mm hex hubs. If using adapters, verify the adapter preserves correct cone-to-hub seating interface before final use.