TRAXXAS 1/10 T-Maxx Precision CNC Aluminium Collars & Screws - TMX13100/SC by GPM  [TMX13100/SC]

CNC-grade alloy collars and mounting hardware

This technical replacement set of alloy collars and mounting screws suits TRAXXAS 1/10 T-Maxx platforms and is itemised as TMX13100/SC. The kit replaces plastic or fatigued metal collars and fasteners, restoring precise axial location and reducing backlash in driveline and linkage connections.

Engineering intent: collars provide positive shaft location for gears, hubs and linkage terminations while the fasteners secure components exposed to repeated service and impact loads. The aluminium material and machining tolerances deliver consistent clamp force with minimal mass penalty for scale fidelity.

Workshop notes: install on a maintenance stand and address one side at a time, remove wheels and hub carriers as needed, remove the old collar, fit the alloy collar and tighten the set screw to the shaft flat, then reassemble and verify unhindered rotation. Use the specified hex driver and apply controlled torque to avoid damaging plastic threaded housings.

Service and setup guidance: refreshed collars can reduce driveline lash and improve steering predictability by keeping linkages accurately indexed. Inspect shaft surfaces for wear prior to installation, degrease contact areas, and recheck fastener torque after initial running to ensure retention under load.