TRAXXAS 1/10 Slash 4x4 Alloy Motor Mount SLA018A by GPM  [SLA018A]

TRAXXAS 1/10 Slash 4x4 Alloy Motor Mount - 1pc set - GPM SLA018A
Price:
USD$23.90
Brand:
GPM
Model:
SLA018A
GTIN:
4894538153088
Condition:
Brand New
Write a review

GPM SLA018A alloy motor mount overview

The SLA018A is a one-piece alloy motor mount supplied as an aftermarket replacement for TRAXXAS 1/10 Slash 4x4 platforms. It secures the motor to the chassis and helps maintain motor-to-pinion alignment under load, using an alloy construction to reduce deformation compared with common plastic mounts. This reduced flex aids consistent mesh during setup and performance testing.

Compatibility is intended for the TRAXXAS 1/10 Slash 4x4 layout; verify mounting hole pattern and motor shaft position against your gearbox and motor plate before fitting. The part is suited for precision setup work or as a replacement for a damaged stock mount where a firmer interface is required.

Installation follows standard procedures for Slash 4x4 cars, with emphasis on careful alignment. Confirm the motor face is parallel to the spur gear, establish a small, even pinion mesh clearance, and ensure no interference with ESC wiring or chassis braces. Regular inspection after running will detect any loosened fasteners or alignment changes.

Specifications

  • Item: TRAXXAS 1/10 Slash 4x4 Alloy Motor Mount
  • Material: Alloy
  • Model Number: SLA018A
  • Compatibility: TRAXXAS 1/10 Slash 4x4

Engineered as a direct aftermarket option for Slash 4x4 users who need a firmer motor mounting point for alignment and tuning, supplied as a single-piece mount by GPM SLA018A.

This item is compatible with

  • TRAXXAS Slash 4X4

What should I check before fitting the SLA018A?

Verify that the motor plate bolt pattern and motor shaft offset match your gearbox, and confirm the chosen pinion does not foul nearby chassis features.

How do I verify correct mesh after installation?

With the motor held in position, rotate the spur and observe tooth contact; set a small, even clearance and then torque mount screws while rechecking mesh to avoid binding.

Any maintenance advice for the alloy mount?

Periodically inspect mounting fasteners for torque retention and check mesh under load cycles. Replace any stripped threads or damaged hardware to maintain secure alignment.