TB-04 CVD Swing Shaft Set Steel #45 - TB4340S by GPM  [TB4340S]

Tamiya TB04 Steel#45 Front/Rear CVD Swing Shaft - 1pr - GPM TB4340S
Price:
USD$10.40
Brand:
GPM
Model:
TB4340S
GTIN:
4894538181616
Condition:
Brand New
Write a review

Precision CVD swing shaft for TB-04 use

Matched front and rear CVD swing shafts supplied as a pair for the TB-04 chassis, machined to steel #45 tolerances for predictable wear characteristics and fitment. These shafts are intended as direct replacements for CVD swing joints found on TB-04 touring layouts.

Fit and function: engineered to match TB-04 hub and suspension geometry, the shafts locate into the existing CVD housings and interface with standard outdrives and wheel hubs. Ensure correct bearing seating and clearance during installation to avoid play or binding.

Installation and tuning considerations: confirm bearing engagement and full suspension travel when installing. The steel #45 construction increases drivetrain rigidity and long term durability, which benefits repeatable setup and reduces component change frequency during competitive or endurance use.

What inspections should be done at fitment?

Verify bearing fit, check for axial and radial play, and confirm the shafts run freely through full suspension articulation before final assembly.

How does steel #45 affect service intervals?

Steel #45 typically extends service life versus softer materials; inspect joint interfaces periodically and replace if wear or deformation appears to protect mating components.

Any setup advice after switching shafts?

Expect increased drivetrain stiffness that can change throttle and traction behaviour; fine tune differential locking and suspension damping to re-establish your preferred handling balance.