TAMIYA XV-02 PRO 7075 CNC Steering Arms and Bridge XV2048 by GPM  [XV2048]

TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048
Price:
USD$21.90
Brand:
GPM
Model:
XV2048
GTIN:
4894538378542
Condition:
Brand New
Write a review
alt="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048" title="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048"
alt="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048" title="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048"
alt="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048" title="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048"
alt="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048" title="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048"
alt="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048" title="TAMIYA XV-02 Aluminium 7075 Steering Arms And Steering Bridge - GPM XV2048"

Machined 7075 aluminium steering kit

This aftermarket steering assembly is engineered for the TAMIYA XV-02 PRO 1/10 4WD chassis and uses 7075-T6 aluminium for superior stiffness at steering pivots. The steering arms and bridge are CNC machined to tight tolerances to improve load transfer to the servo and linkages while minimising deflection. Bearings and mounting hardware are included, with fittings pre-installed to reduce build time and ensure repeatable alignment.

As a tuning upgrade rather than a geometry change, the components stabilise toe and ackermann under dynamic loads, improving steering consistency during aggressive inputs. Installation replaces the factory plastic steering parts and usually allows reuse of original linkages; fastener torque should be set for aluminium and alignment verified to avoid binding.

Packing includes

  • Steering arms and steering bridge - 3pcs
  • Bearing 5x8x2.5 - 4pcs
  • Bearing 3x8x3 - 2pcs
  • Stainless steel shim 5x8x0.1 - 2pcs
  • Grade 12.9 black round head screws 3x10 - 2pcs
  • All fittings are installed on the goods - 1pcs

Compatible Models

  • TAMIYA-1/10 4WD XV-02 PRO CHASSIS-58707

This CNC 7075 steering upgrade is intended for hobbyists seeking a durable, low-compliance solution to refine steering behaviour and aid setup development on the XV-02 PRO chassis.

What tolerances are used for the machined parts?

Parts are CNC machined to tight tolerances suitable for bearing press fits and repeatable pivot locations; bearings are supplied to match the bores listed in Packing includes.

Any recommended servo specs?

A metal-geared servo with sufficient torque is recommended to take advantage of the reduced compliance; check servo spline fit and horn alignment during installation.

How should I set screw torque for these aluminium parts?

Use moderate torque values appropriate for aluminium to avoid stripping; apply threadlocker to critical metal-to-metal joints and re-torque after initial running.