TAMIYA XV01 Front CVD Swing Shaft Spring Steel XV1240FST by GPM  [XV1240FST]

Tamiya XV01 Spring Steel Front CVD Swing Shaft - 1pr - GPM XV1240FST
Price:
USD$22.90
Brand:
GPM
Model:
XV1240FST
GTIN:
4894538238310
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical overview of the XV-01 front CVD swing shaft

The XV1240FST front CVD swing shaft is an aftermarket replacement designed for TAMIYA XV01 front drive systems. As a direct-fit spring steel component, it maintains factory geometry while aiming to reduce driveline play and extend service life under regular touring use.

Precision in installation is important: orient the shaft correctly and ensure all mating surfaces are clean and free from contaminants. Confirm CVD cups and pins are in good condition and torque retention hardware to the model's specified values. The increased stiffness from the spring steel element can change steering feedback, so make incremental setup changes and validate handling on a test run.

Recommended when replacing worn XV-01 front CVD swing shafts or when a more wear-resistant front drive link is needed for consistent handling in club or track environments.

Specifications

  • Item: Front CVD swing shaft
  • Material: Spring steel
  • Model Number: XV1240FST
  • Compatibility: Tamiya XV01
  • Quantity: 1pr

How do I confirm correct fitment of XV1240FST?

Measure shaft length and check cup engagement against your XV-01 front hubs; a visual comparison to the original part ensures proper orientation before final assembly.

What inspection points maximise life of the shaft?

Inspect the joint interfaces for wear, ensure pins are straight and cups rotate freely, and keep the area free from grit which accelerates wear.

Will the spring steel shaft alter tuning requirements?

Yes, the firmer front response can require small adjustments to toe, caster or damping to preserve desired handling balance. Test changes incrementally.

Are additional hardware changes typically needed?

Usually no extra parts are required; however, replace any worn CVD cups or pins to ensure correct fit and avoid premature wear.