Tamiya XV-01 CNC-Style Alloy Steering Upgrade XV048 by GPM  [XV048]

Tamiya XV01 Alloy Steering Assembly With 5x8 Bearings - 3pcs set - GPM XV048
Price:
USD$14.90
Brand:
GPM
Model:
XV048
GTIN:
4894538237993
Condition:
Brand New
Write a review

CNC-style alloy steering assembly for XV-01

This CNC-inspired alloy steering assembly is engineered for the Tamiya XV-01 platform and shipped as a 3pcs set. It replaces standard plastic steering link components with a machined aluminium unit that carries installed 5x8 bearings, designed to deliver a firmer pivot point and a repeatable mechanical interface to the servo output horn.

Installation follows standard XV-01 procedures: remove existing plastic steering pieces and refit compatible stock linkages and hardware. Confirm bearings are fully seated and verify steering geometry to prevent binding, since small servo horn misalignments can translate into variable steering input during precise tuning sessions.

Intended as a durability and performance upgrade, this assembly reduces play in the steering system and improves consistency across test runs and setup changes. The kit includes 3pcs, each pre-fitted with a 5x8 bearing for direct fitment where XV-01 steering geometry is retained.

What tolerances should I check during fitment?

Check bearing bore seating and linkage alignment; ensure axial play is within the expected range and that the servo horn centres without preload to avoid steering bias.

Can the bearings be replaced with sealed types?

Yes, the housing accepts standard 5x8 bearing profiles, allowing you to install sealed or higher-grade bearings if required for longevity or reduced friction.

Recommended inspection intervals?

Inspect bearings and fasteners after the first few runs and then at regular maintenance intervals, tightening hardware and replacing bearings if any lateral play is detected.