TAMIYA Wild Dagger Precision Rear Camber Arm Alloy WD057 by GPM  [WD057]

Tamiya Wild Dagger Alloy Rear Camber With Collars & Screws - 1pr set - GPM WD057
Price:
USD$11.30
Brand:
GPM
Model:
WD057
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical overview

The GPM WD057 rear camber arm is a machined alloy aftermarket component produced for the TAMIYA Wild Dagger chassis. It is supplied with collars and mounting screws that correspond to the original mounting pattern, providing a direct-replacement option for the rear camber/hub area.

Designed with attention to fitment and repeatability, the alloy construction increases mounting rigidity and helps maintain camber indexing under typical running loads. Collars are included to ensure correct axial spacing during reassembly, supporting consistent setup replication.

Installation requires standard rear hub removal and refit procedures used on the Wild Dagger; the part utilises the supplied hardware for a straightforward fit. When adjusting camber settings, make controlled incremental changes and validate handling on a test surface before finalising the setup.

What checks should be made before fitting?

Confirm rear hub bore and mounting hole alignment against the supplied arm to ensure a correct fit, and inspect hardware for proper thread engagement before final torqueing.

How do the collars affect reassembly accuracy?

The collars control axial spacing and help reproduce the same camber index after disassembly, improving repeatability between runs.

Any setup advice for tuning camber with this arm?

Make incremental camber changes and log handling outcomes; check that fasteners remain secure after initial runs and re-torque if necessary to maintain consistent alignment.