TAMIYA TT01 Delrin Shaft Collars TT054D/DC for TT054D Drift Arm by GPM  [TT054D/DC]

Tamiya TT01 Delrin Collars For Tt054d Drift Arm-4pcs Net Price - GPM TT054D/DC
Price:
USD$1.50
Brand:
GPM
Model:
TT054D/DC
GTIN:
4894538212891
Condition:
Brand New
Write a review

Engineered Delrin collars for TT01 drift arms

Technical kit of four Delrin collars produced for use with the TT054D drift arm on the TAMIYA TT01 chassis. These polymer collars provide controlled clearance and low-friction bearing against shaft or spacer surfaces to support consistent alignment in drift setups.

Intended exclusively for the TT054D drift arm application on the TT01 platform. Delrin is selected for predictable dimensional stability and wear resistance when deployed with common shaft materials found in R/C suspension systems.

Installation notes: treat these parts as precision spacers or shaft locators rather than roller bearings. Verify inner bore tolerance and axial seating prior to final torqueing. Use them to make fine adjustments to toe and camber influence at the drift arm without replacing primary suspension hardware.

What measurements should I confirm before fitting?

Confirm the drift arm bore diameter and shaft outer diameter to ensure the Delrin collar inner bore provides the intended interference or slip fit for your setup.

How are these collars typically used in tuning?

Use as axial locators or spacers to alter effective toe and camber inputs from the drift arm while keeping primary suspension geometry unchanged.

When should a collar be replaced?

Replace when inner bores show ovaling or when abrasion on mating faces permits excessive play that affects alignment precision.