TAMIYA T3-01 Precision 9mm Rear Wheel Hex T3010/9MM by GPM  [T3010/9MM]

Precision 9mm rear wheel hex for T3-01

This aluminium rear wheel hex is supplied as 1pair and is intended as an RC spare for the TAMIYA T3-01 Dancing Rider. It establishes the 9mm interface used to secure wheels to the T3-01 rear hubs and provides a durable metal alternative to factory plastic hexes without changing original hub geometry.

Fitment guidance: verify the 9mm hex fully seats into the wheel hub and that the wheel bore alignment is correct prior to final torque. After installation, inspect for axial play and adjust wheel seating as required to avoid uneven tyre wear. Use this part as a direct replacement or a minor hub-stiffening upgrade.

Inspection and service: aluminium construction resists permanent deformation under load better than common plastics, assisting with consistent wheel alignment during demanding on-road use. Periodically check for surface wear or corrosion if exposed to moisture and replace the hex if any burrs or structural deformation are detected.