Tamiya M1025 Hummer Rear Knuckle Arm HM1022 by GPM  [HM1022]

Tamiya M1025 Hummer Aluminium Rear Knuckle Arm - 1pr set - GPM HM1022
Price:
USD$15.10
Brand:
GPM
Model:
HM1022
GTIN:
4894538075618
Condition:
Brand New
Write a review
alt="Tamiya M1025 Hummer Aluminium Rear Knuckle Arm - 1pr set - GPM HM1022" title="Tamiya M1025 Hummer Aluminium Rear Knuckle Arm - 1pr set - GPM HM1022"
alt="Tamiya M1025 Hummer Aluminium Rear Knuckle Arm - 1pr set - GPM HM1022" title="Tamiya M1025 Hummer Aluminium Rear Knuckle Arm - 1pr set - GPM HM1022"
alt="Tamiya M1025 Hummer Aluminium Rear Knuckle Arm - 1pr set - GPM HM1022" title="Tamiya M1025 Hummer Aluminium Rear Knuckle Arm - 1pr set - GPM HM1022"

Precision aluminium rear knuckle arm for M1025 Hummer

This aluminium rear knuckle arm is a dedicated RC replacement for Tamiya M1025 Hummer installations, model HM1022. Specified as an aftermarket component, it replaces factory plastic knuckles to provide a firmer, more consistent mounting location for suspension linkages on TA-01 and TA-02 compatible chassis.

Intended use covers setup work and routine maintenance where a more repeatable knuckle mounting point is required. After fitting, verify wheel bearing preload and linkage angles to restore correct suspension geometry and ensure predictable handling.

Fitting procedure: remove the stock knuckle, transfer bearings and fasteners as needed, install the aluminium knuckle in the original orientation, and confirm axle and hub hardware are correctly torqued before operation.

Specifications

  • Item: Tamiya M1025 Hummer Aluminium Rear Knuckle Arm
  • Material: Aluminium
  • Model Number: GPM HM1022
  • Compatibility: Tamiya M1025 Hummer, TA-01/TA-02

A practical, precision-focused aluminium knuckle for model builders tuning suspension response on M1025 Hummer and compatible Tamiya chassis.

Is the HM1022 a direct replacement for the stock knuckle?

Designed for direct replacement on standard M1025 rear mounts. Confirm chassis version and transfer bearings to retain proper axle spacing.

What should I reuse from the original assembly?

Reusing original bearings and fastening hardware is recommended unless those items are worn. This preserves bearing fit and wheel geometry.

How does an aluminium knuckle aid setup work?

Aluminium increases knuckle stiffness and provides a stable mounting surface, improving repeatability when adjusting toe and linkage geometry during setup.

Final assembly checks to perform after fitting HM1022?

Confirm bearing preload, torque hub and axle hardware to specification, and remeasure toe and camber to prevent binding and ensure handling consistency.