TAMIYA HOTSHOT II HS2010 Precision 7075 Wheel Hexes by GPM  [HS2010]

7075 Alloy Wheel Hexes for HOTSHOT II

This aftermarket wheel hex set is intended for the TAMIYA HOTSHOT II platform and is supplied as model HS2010. Machined to serve as a direct RC-scale replacement, the hexes use 7075 aluminium to provide high strength with low mass for better hub stability and tuning consistency.

On the 1/10 HOTSHOT II the hexes replace the wheel mounting interface to restore concentric wheel seating and reliable alignment. The 7075 material selection reduces the chance of deformation under normal running loads while keeping rotating mass minimal for improved dynamic response.

Installation requires verification of hub fit on HOTSHOT II components and reuse of the original wheel fastening hardware where appropriate. Check seating and fastener engagement prior to each run for safe operation.

HS2010 7075 hexes are intended to repair and upgrade HOTSHOT II wheel interfaces, maintaining precise mounting for consistent setup and handling.