TAMIYA GF01/TL01 Precision Rear Camber Aluminium GF057 by GPM  [GF057]

Tamiya GF01 Aluminium Rear Camber - 1pr set (For GF01 / TL01) - GPM GF057
Price:
USD$7.90
Brand:
GPM
Model:
GF057
GTIN:
4894538039085
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision machined rear camber for GF01/TL01 platforms

The GPM GF057 aluminium rear camber is an aftermarket upgrade developed for TAMIYA GF01 and TL01 chassis, supplied as a 1 pr set to replace stock rear camber links with a firmer machined aluminium option.

Intended for hobbyists seeking consistent rear suspension geometry, this aluminium arm reduces flex at the hub and aids repeatable camber settings under load. The item is identified as aluminium and is compatible with standard GF01/TL01 rear mounting points.

Installation follows standard GF01/TL01 procedures: remove original camber components, fit the aluminium arm to factory mounts, check for correct clearance and alignment, and verify fastener torque after initial runs. Regular inspection of mounting interfaces is recommended for long term fitment stability.

Compatible Models

  • GF01
  • TL01

Is this a direct replacement for the factory camber arm?

Yes, GF057 is produced for direct fitment to GF01 and TL01 rear mounting points and replaces the original camber arm without chassis modification.

What are the recommended post-fit checks?

After fitting, verify camber alignment and suspension travel for interference, then re-torque fasteners following a short on-track or backyard run.

Does the aluminium arm require different setup compared with plastic?

Aluminium reduces compliance versus plastic, so drivers should expect more consistent geometry; minor suspension retuning may be beneficial to optimise handling.