TAMIYA DT03 Servo Mount Precision Aluminium DT3024 by GPM  [DT3024]

Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024
Price:
USD$14.90
Brand:
GPM
Model:
DT3024
GTIN:
4894538051957
Condition:
Brand New
2 Reviews
Write a review
alt="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024" title="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024"
alt="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024" title="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024"
alt="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024" title="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024"
alt="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024" title="Tamiya DT03 Aluminium Servo Mount - 1pc - GPM DT3024"

Aluminium servo mount for DT03

This aluminium servo mount is an aftermarket replacement part produced by GPM for the TAMIYA DT03 platform and supplied as 1 pcs. It secures a standard-sized servo to the DT03 mounting points while increasing local stiffness at the servo mounting area to reduce deflection under steering loads.

Made for workshop tuning and repeatable setup, the mount stabilises servo positioning and aids finer steering calibration. Installation aligns with the DT03 factory mounting holes; position the mount, check screw hole alignment precisely and fasten using original or equivalent fasteners to maintain correct servo orientation and repeatable geometry.

 

Product Reviews
2 Reviews
rating
I bought several parts off you guys for a few different Tamiya chassis. Love the quality of your products. Can I ask why you do not have any parts for the Tamiya CR-01 chassis?
rating
Thank you very much, all arrived safely. Thank you very much for this first transaction from Japan to my beautiful France. Good luck and thank you again from the bottom of my heart. See you next time and good luck in the land of the rising sun. ++++

What are the fitment checks before final tightening?

Confirm the mount sits flush against the chassis, verify that all screw holes line up with the DT03 pattern and ensure the servo output shaft is centered with the steering linkage before final torque is applied.

Should I reuse original screws or fit replacements?

Reusing original DT03 fasteners is acceptable if they are in good condition; replace any worn screws with equivalent grade fasteners to preserve clamping and alignment.

Does this mount alter recommended servo endpoints?

The mount retains original servo position relative to the chassis, so endpoint and subtrim settings typically remain unchanged, though a quick check and small trims after install are recommended.