TAMIYA CC-01 Precision Centre Drive Shaft 138-145mm SCC037SAAL by GPM  [SCC037SAAL]

Precision centre drive for CC-01

This centre drive shaft is a scale replacement intended for TAMIYA CC-01 platforms, specifically for Volkswagen Amarok builds with a 267mm wheelbase. The assembly pairs steel sections with an aluminium body to provide a balance of durability at torque points and controlled mass, while offering length adjustment from 138mm to 145mm to address small chassis spacing variations.

The aluminium section accepts finishing options such as anodising, and the steel portions are positioned at wear and torque transfer locations. The compact profile preserves original gearbox geometry and is focused on improving drivetrain reliability without altering mounting positions.

Installation is aimed at experienced hobbyists familiar with CC-01 layouts: the shaft replaces the stock centre drive and integrates with existing mating parts. Typical hobby hex drivers are sufficient; verify spline engagement, axial alignment, and rotational freedom during trial assembly to avoid binding and ensure correct operation.

Recommended for replacing worn centre drives or when a measured length adjustment is required on CC-01 Amarok setups; perform a careful dry fit, then secure hardware and apply light lubrication to splines and threads for consistent service.