Slash 4x4 Precision Turnbuckle Set SSLA160P by GPM  [SSLA160P]

Precision-engineered spring steel turnbuckles

This 7pcs completed turnbuckle set is intended for TRAXXAS Slash 4x4 platforms and Telluride models. Each assembly uses hardened spring steel rod sections with fitted plastic ball ends and is supplied ready for installation into existing linkage points.

Designed as direct-fit replacements where the ball end interface and length match, the assemblies provide corrosion-resistant spring steel shafts and low-friction plastic joints suitable for steering and rear toe adjustments. The components are aimed at hobbyists seeking reliable, repeatable linkage geometry during setup and tuning.

Supplied as a ready-to-install kit, the seven completed linkages remove the need to assemble rods and ball ends, speeding maintenance and replacement of bent or fatigued parts.

Use these completed turnbuckles to retain steering precision and consistent toe settings, noting they are intended specifically for Slash 4x4 and Telluride linkage configurations.