SCX10 Aftermarket Main Drive Shaft Set F:123-133mm R:118-128mm SCX037SA by GPM  [SCX037SA]

Technical overview of front and rear main drive shafts

This replacement kit supplies a front and rear main drive shaft pair for AXIAL Racing SCX10 platforms. The design pairs steel at spline contact points with aluminium sections to manage rotating mass while maintaining wear resistance at load-bearing interfaces, and the set is packaged as two pieces for front and rear positions.

Provided length ranges are front 123mm-133mm and rear 118mm-128mm to suit common SCX10 driveline arrangements. These shafts transmit torque from the gearbox to axle assemblies and will influence driveline stiffness, axial endplay and overall drivetrain behaviour. Installers should verify spline engagement, axial clearance and alignment to prevent binding and ensure reliable service life.

Recommended for builders needing direct-fit lengths for SCX10 front and rear shafts while retaining a steel/aluminium component strategy to balance durability and rotating mass.