Scania R620 Precision Alloy Servo Mounts TRU204SC by GPM  [TRU204SC]

Tamiya Tractor Truck Alloy Servo Mounts - 5pcs set (For Scania R620) - GPM TRU204SC
Price:
USD$18.90
Brand:
GPM
Model:
TRU204SC
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision Alloy Servo Mounts for Scania R620 Applications

This 5-piece aftermarket servo mount set is manufactured as an aluminium upgrade for Tamiya tractor truck layouts following the Scania R620 mounting pattern. Each machined component is intended to replace higher-compliance plastic mounts to increase local stiffness at the servo attachment.

The assembly purpose is to provide a stable servo interface that reduces deflection under steering load and improves repeatability of mechanical input. During assembly, confirm servo spline orientation, horn clearance, and steering link angles to maintain intended travel without binding.

Installation guidance: use the original chassis mounting points where feasible, reuse compatible hardware, and carry out a test fit with the servo to verify geometry before final torque. For best results check fastener torque after initial use.

Compatible Models

  • Scania R620

A technical upgrade for users seeking a more stable servo mounting solution on Tamiya Scania R620 scale tractor trucks to support consistent steering setup and tuning.

Which components are supplied with TRU204SC?

The kit supplies five precision alloy servo mount pieces designed to occupy the standard Scania R620 servo mounting locations.

Do these mounts require different fasteners?

In most cases original mounting screws can be reused; however check length and thread engagement and replace with appropriate fasteners if clearance or fit varies.

How do they affect steering geometry under load?

The stiffer mounting surface reduces micro-movements at the servo interface, which helps maintain consistent steering geometry and improves repeatability during precise driving.

Recommended installation checks?

Verify spline alignment, horn clearance and linkage angles during a dry fit, then confirm torque after initial runs to ensure no loosening occurs.