Replacement Aluminum Stand Hardware GPM/STAND/PA by GPM  [GPM/STAND/PA]

GPM RC Car / Truck Aluminum Stand Rebuild Kit Replaces Factory Plastic Components, Locking Lever/ Assembly Hardware Number (#8791) - GPM GPM/STAND/PA
Price:
USD$27.90
Brand:
GPM
Model:
GPM/STAND/PA
Condition:
Brand New
Write a review

Stand rebuild components in machined aluminum

This rebuild kit replaces the factory plastic parts on compatible RC car and truck stands with machined aluminum components and the supplied hardware. It is intended to restore or improve the mechanical interface of a bench stand used for maintenance and setup while maintaining the stand's original function.

The items are provided as a full hardware set ready for fitting into the stand assembly. Use basic hand tools to remove the plastic pieces and fit the new aluminum parts and fasteners, keeping bearings and shafts aligned. The aluminum offers increased rigidity to help sustain consistent setup geometry through repeated use.

Packing includes

  • RC Car / Truck Aluminum Stand Rebuild Kit - 1set
  • Bearing 15x24x5mm - 2pcs
  • Nylon Washer 17x39x1mm - 1pcs
  • Grade 12.9 black Round Head Screw 4x25mm - 1pcs
  • Grade 12.9 black Round Head Screw 3x22mm - 1pcs
  • Grade 12.9 black Flat Head Screw 3x10 - 6pcs
  • M4 Lock Nuts - 1pcs
  • Screw Shaft 4x3mm - 1pcs
  • Steel ball 3mm - 1pcs
  • Spring 3x10mm - 1pcs

Original Name / Part No:

8791

Specifications

  • Item RC Car/Truck Aluminum Stand Rebuild Kit
  • Material Aluminum
  • Model Number GPM/STAND/PA
  • Compatibility For stand #8796 or #8797

A direct aluminum replacement for the original plastic stand parts, provided for hobby bench use where greater rigidity and repeatable setup are required.

What components does the rebuild kit replace?

It substitutes the factory plastic parts on the compatible RC stand, including the locking lever and associated assembly hardware, with machined aluminum pieces and supplied fasteners.

Which items are included in the kit pack?

The pack contains the rebuild kit, bearings, nylon washer, Grade 12.9 screws, flat head screws, M4 lock nut, screw shaft, steel ball, and spring as listed in the packing section.

Are the screws high strength?

Yes, the specified screws are Grade 12.9 black fasteners which provide higher strength than general purpose screws and are used for key joints in the assembly.

Will this kit fit my stand model?

The kit is intended to fit the listed stand models and replaces the factory plastic parts; confirm your stand is model #8796 or #8797 or has compatible mounting geometry before installing.