Precision Rear CVD Joint SSLA1277A/JT for Slash 4x4 by GPM  [SSLA1277A/JT]

TRAXXAS 1/10 Slash 4x4 Stainless Steel Joint For Ssla1277rha Rear CVD Drive Shaft - 3pc set - GPM SSLA1277A/JT
Price:
USD$4.00
Brand:
GPM
Model:
SSLA1277A/JT
GTIN:
4894538324785
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review
alt="TRAXXAS 1/10 Slash 4x4 Stainless Steel Joint For Ssla1277rha Rear CVD Drive Shaft - 3pc set - GPM SSLA1277A/JT" title="TRAXXAS 1/10 Slash 4x4 Stainless Steel Joint For Ssla1277rha Rear CVD Drive Shaft - 3pc set - GPM SSLA1277A/JT"

Engineered rear CVD joint for Slash 4x4 driveline

CNC-style stainless replacement joint engineered for 1/10 scale rear CVD connection points. Supplied as a 3 pcs set and intended as a direct swap for the matching joint end.

Compatibility statement: designed to replace joint end part #SSLA1277RHA. Confirm spline and bore dimensions against your existing assembly before installation to ensure correct engagement.

Material specification: stainless steel construction enhances tensile strength and corrosion resistance relative to standard alloys, helping maintain structural integrity under torque and impact loads typical in off-road RC use.

Installation procedure: remove the rear driveline to access the joint end, torque small fasteners to controlled values to avoid stripping, and verify axial alignment and free rotation following assembly. Use appropriate hand tools and check spline engagement.

Included items in package and counts as supplied by source: joint - 1 pcs, hex - 1 pcs, 3x3 screw shaft - 1 pcs, supplied as a 3 pcs set.

This item is compatible with

  • TRAXXAS Slash 4X4
  • TRAXXAS SLASH 4X4 LOW CG
  • TRAXXAS F-150 SVT Raptor
  • TRAXXAS Slash PRO Short Course

What critical dimensions should I check before fitting?

Measure spline count, internal bore diameter and shaft diameter at the joint interface; ensure these match the replacement to avoid play or binding.

Recommended maintenance for stainless joints?

Inspect fasteners and spline interface regularly, remove debris after muddy or sandy runs, and apply light lubrication where applicable to preserve movement without trapping grit.

What torque practice is advised for the small screws?

Use low controlled torque appropriate for small fasteners to prevent stripping; if no torque spec is available, tighten until secure with no thread damage and confirm by manual checking of engagement.