Precision Front Upper Suspension Arm 7075-T6 DT4054 for TAMIYA DT-04 by GPM  [DT4054]

Precision 7075-T6 front upper arm for DT-04

This front upper suspension arm is manufactured from 7075-T6 aviation-grade aluminium with a focus on precision and durability, intended as a direct RC-scale replacement for the factory front upper arm on the TAMIYA DT-04 RC FIGHTER NXGEN chassis. The design supports chassis loads, stabilises the front knuckle, and provides a consistent tuning datum for front-end setup without implying any real vehicle application.

Produced with wear and impact resistance in mind, the arm is anodized and supplied in sky blue, black, and silver finishes. The kit is delivered with the small hardware pre-assembled to the arm; technicians should use a medium-strength screw glue on the fasteners after alignment to limit vibration-induced loosening.

Part location: front upper suspension arm area; this CNC-friendly component replaces the factory front upper suspension arm and serves as an RC-scale hop-up for 1/10 DT-04 chassis maintenance and handling optimisation.

Install this precision arm to restore or fine tune front geometry; confirm fitment to the listed compatible model and apply medium-strength threadlocker to the pre-assembled fasteners for reliable, long-term performance.