Precision front C-hub aluminium upgrade CRA019 for TRAXXAS Craniac by GPM  [CRA019]

TRAXXAS 1/10 Craniac Monster Truck Aluminium Front C-Hub - 1pr set - GPM CRA019
Price:
USD$19.90
Brand:
GPM
Model:
CRA019
GTIN:
4894538045475
Condition:
Brand New
Write a review

Precision CNC-style aluminium C-hub for steering assemblies

This aluminium front C-hub pair is engineered as a direct-fit upgrade for the TRAXXAS 1/10 Craniac Monster Truck platform and is supplied as a single pair for the front suspension. The component is intended for hobby model applications and not for full-size vehicle use.

Functionally, the C-hub forms a structural mounting point within the steering knuckle, securing the hub carrier and affecting critical steering geometry and wheel alignment. Upgrading from plastic to aluminium increases rigidity and consistency under load; verify bearing fitment and fastener torque when installing to prevent binding and retain intended steering characteristics.

Assembly notes: disassemble the front hub and axle assembly, transfer sealed bearings or pivot pins as required, and fasten the aluminium C-hub using the original hardware where possible. Confirm unobstructed suspension travel and ensure no interference with the servo horn or steering linkage post-installation.

Specifications

  • Item: Aluminium Front C-Hub set - 1pr
  • Material: Aluminium
  • Model Number: CRA019
  • Compatibility: TRAXXAS 1/10 Craniac Monster Truck

A precision-aligned aluminium C-hub for hobbyists aiming to reduce flex and improve repeatable steering geometry on the specified TRAXXAS Craniac.

This item is compatible with

  • TRAXXAS CRANIAC

What checks should be done after installation?

Verify bearing seating, confirm correct fastener torque, and cycle the suspension to ensure no binding across full travel.

Does aluminium change steering geometry?

Aluminium can affect feedback due to reduced flex; geometry dimensions remain the same but feel and repeatability may improve.

Are any machining adjustments required?

No machining is required for direct-fit installation, but confirm that transferred bearings and pivot pins seat flush and that fasteners do not protrude into moving components.

What regular inspections are recommended?

Periodically inspect mounting hardware torque, bearing condition, and contact surfaces for signs of wear or fretting after heavy runs.