Precision Front Arm Bulk RUS008 for TRAXXAS Rustler VXL by GPM  [RUS008]

Precision alloy front arm bulk for Rustler VXL

This aftermarket alloy front arm bulk is engineered for TRAXXAS 1/10 Rustler VXL models as a direct replacement for the original plastic bulkheads. The component delivers a firmer pivot mounting that influences steering geometry, toe retention and camber behaviour under dynamic loads.

Installation follows standard workshop practice: remove the front suspension assembly, replace the bulkheads, verify bearing and pin seat alignment and reassemble with thread locker where appropriate. Standard hex tools and wrenches are sufficient, but confirm clearance and fitment on the chassis before final torqueing.

From a setup perspective, the RUS008 alloy bulk reduces pivot compliance and provides a more predictable steering response when refining turn-in and mid-corner balance. Use the part for repair, service and progressive tuning tasks on 1/10 Rustler VXL vehicles.

Install the RUS008 alloy bulk to replace worn front bulkheads and to provide a firmer foundation for suspension tuning on TRAXXAS Rustler VXL platforms.